It is measured by measuring voltage across the terminals of the cell when no load is connected to the cell. Where, I sc is short circuit current, J sc maximum current density and A is the area of solar cell.

Maximum current density or short circuit current density rating is nothing but ration of maximum or short circuit current to exposed surface area of the cell. As the current production also depends upon the surface area of the cell exposed to light, it is better to express maximum current density instead maximum current. The term optimized condition I used because for fixed exposed cell surface the rate of production of current in a solar cell also depends upon the intensity of light and the angle at which the light falls on the cell. It is measured by short circuiting the terminals of the cell at most optimized condition of the cell for producing maximum output. The maximum current that a solar cell can deliver without harming its own constriction. These parameters tell us how efficiently a solar cell can convert the light to electricity. During choosing a particular solar cell for specific project it is essential to know the ratings of a solar panel. This was basic working principle of a solar cell now we will discuss about different parameters of a solar or photovoltaic cell upon which the rating of a solar panel depends. In this way a potential difference is established between two sides of the cell and if these two sides are connected by an external circuit current will start flowing from positive to negative terminal of the solar cell. Similarly the light-generated holes created near the junction are migrated to p-type side of the junction due to same electrostatic force. The light-generated electrons near the p-n junction are migrated to n-type side of the junction due to electrostatic force of the field across the junction. These electrons and holes of e-h pairs are called light-generated electrons and holes. Hence, one valence electron gets energy from one photon and becomes excited and jumps out from the bond and creates one electron-hole pair. Some of the absorbed photons will have energy greater than the energy gap between valence band and conduction band in the semiconductor crystal.

While sunlight falling on the cell the some photons of the light are absorbed by solar cell. A semiconductor p-n junction is in the middle of these two contacts. Typically a solar or photovoltaic cell has negative front contact and positive back contact. Each of the solar cells has one positive and one negative terminal like all other type of battery cells.

The solar cell produce electricity while light strikes on it and the voltage or potential difference established across the terminals of the cell is fixed to 0.5 volt and it is nearly independent of intensity of incident light whereas the current capacity of cell is nearly proportional to the intensity of incident light as well as the area that exposed to the light. A solar cell is basically a semiconductor device. The working of a solar cell solely depends upon its photovoltaic effect hence a solar cell also known as photovoltaic cell. Solar cell is the basic unit of solar energy generation system where electrical energy is extracted directly from light energy without any intermediate process.

Hair snippery millville delaware