smart shooter disable last picture overlay

#Smart shooter disable last picture overlay full#

#Smart shooter disable last picture overlay full#

'Card Full ': if the loop recording function is enabled the dash cam will operate properly and the oldest files wiull be automatically deleted, otherwise this message will appear on the screen everytime the card becomes full. The dash cam's screen displayed 'Card Full/Error' If this happens the dash camera will switch off too.

If you have a stop/start vehicle, amke sure that the 12V power socket does not power down when the vehicle enters stop/start mode.

Check 12V power socket on Stop/Start vehicles.

Check the cable for damage, which may have caused the fuse to blow.

Check whether the fuse in the end of the adapter is not blown.

If the LED flickers or goes out during use, then the power adapter may not be securely fitted into the socket, causing the camera to power off.

Ensure that the 12V power adapter is securely fitted into the car power socket, the LED is always illuminated, the engine is switched on.

Make sure the SD card used is not UHS -Ultra High Speed type (indicated by a number inside a 'U'), as these may not be compatible with the current dash cameras.

Make sure the SD card is compatible with camera.

Highlighted in red are speeds for the Class6 & Class10 cards recommended for use with common dash cameras. The table below shows expected transfer rates for each class of SD card. If you wish to check the speed of an SD card there are programs available such as HD Tune which can confirm the data transfer rate.

Make sure the SD card is not fake: there are some fake SD cards on the market, which may not perform to their specified speed and cause recording problems, especially when recording at Full HD resolution.

If the card recording is not fast enough files may become corrupted.

Check your SD card speed: use a SD card with a speed of at least Class6.

The car DVR / dash cam recording is intermittent If the camera has not been used for some time and the internal battery is fully discharged, it may take a few minutes before there is sufficient energy from the power adapter to charge the battery and power the dash camera. This can happen if the internal battery is heavily discharged. This may give the impression recording has stopped but it will still be recording in background.Ĭamera does not start recording after ignition switched on This feature will switch off the LCD screen after a selected time in order to reduce distraction at night. Turn off the back light or enable power save function.

For larger SD cards this feature is not required. When movement is detected the camera will start recording again.

For smaller SD cards, this feature will stop recording whenever no motion is detected in front of the camera.